My
wig was very long and not only did this not suit the 1940’s hairstyles I was
designing but also the hair at the bottom of the wig was a lot thinner and
therefore did not look as good as the rest of the wig. Therefore it needed
cutting and my friend Lily very kindly offered to cut it for me. I was going to
cut it myself but as Lily is a trained hairdresser I accepted the offer as I
knew she would do a lot better job than I would be able to and I was very
pleased with the results. The photographs above show my wig before and after it was cut, thank you Lily!
The first thing I did to prepare my wig for the assessment was to section off the front of the hair that would be used for the curls at the sides. I then put in an off centre parting and put rollers in going in the direction away from the parting. I used medium sized rollers as I thought this would create a nice size of curl especially at the ends of the hair. At the sides I had the rollers going backwards to try and create curls and movement in the hair that would look good when shaped and pinned in place.
At the back of the hair I did the rollers in a brick work pattern to create 1940's style curls that would give me a good texture to work with. The rollers at the top are smaller because for my design I wanted to have nice curls that I could pin into place to be decorative. The rollers at the very top of the brick work are at a slightly different angle because the hair of the wig was shorter and difficult to roller horizontally. At the bottom of the hair is where the padding was going to be so I did not need the top of this section of hair to be curly so I used bigger rollers.

I left the hair to dry for several days and then took the rollers out to check that the hair had set properly how I wanted it to and it had. I made sure that the front section was still separated from the back so that the curls did not get mixed together and it was ready for my assessment.





















No comments:
Post a Comment